HP 10500 Switch Series - HP 10500-CMW710-R2105P05 Release Notes

# Copy the file to the standby MPU in slot 1 of member device 1.

<Sysname> copy newest.bin chassis1#slot1#flash:/

Copy flash:/newest.bin to chassis1#slot1#flash:/newest.bin?[Y/N]:y

Copying file flash:/newest.ipe to chassis1#slot1#flash:/newest.ipe...Done.

# Copy the file to the standby MPU in slot 0 of member device 2.

<Sysname> copy newest.bin chassis2#slot0#flash:/

Copy flash:/newest.bin to chassis2#slot0#flash:/newest.bin?[Y/N]:y

Copying file flash:/newest.ipe to chassis2#slot0#flash:/newest.ipe...Done.

# Copy the file to the standby MPU in slot 1 of member device 2.

<Sysname> copy newest.bin chassis2#slot1#flash:/

Copy flash:/newest.bin to chassis2#slot1#flash:/newest.bin?[Y/N]:y

Copying file flash:/newest.ipe to chassis2#slot1#flash:/newest.ipe...Done.

NOTE:

You can configure the switch as the FTP server, FTP client, or TFTP client. The transfer procedures vary

slightly. For more information about FTP and TFTP, see

HP 10500 Switch Series Fundamentals

Configuration Guid

Upgrading software from the CLI

Before upgrading software, verify that the software file is stored in the root directory of the flashes on the

MPUs.

Perform the following tasks as needed:

 Upgrade BootWare

 Upgrade Comware software

 Install a patch package

1. Upgrade BootWare

The following example uses new.bin to upgrade the BootWare.

NOTE:

The BootWare image stored on the active MPU can be used to upgrade the active MPU, LPUs, and

switching fabric modules while that stored on a standby MPU is used to upgrade the standby MPU only.

# Upgrade the BootWare on the global active MPU.

<Sysname> bootrom update file flash:/new.bin chassis 1 slot 0

This command will update bootrom file on the specified board(s),

Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Upgrade the BootWare of the standby MPU in slot 1 of member device 1. (Upgrade other

standby MPUs in the same way.)

<Sysname>bootrom update file chassis1#slot1#flash:/new.bin chassis 1 slot 1

This command will update bootrom file on the specified board(s), Continue? [Y/N]:y

Now updating the Boot ROM, please wait........... ...........Done.

# Upgrade the BootWare of the LPU in slot 3 of member device 2. (Upgrade other LPUs in the same

way.)

<Sysname>bootrom update file flash:/new.bin chassis 2 slot 3

This command will update bootrom file on the specified board(s), Continue? [Y/N]:y