HP 10500 Switch Series - HP 10500-CMW710-R2105P05 Release Notes

43
Option
Tasks
<3> Update Backup Image File
Download a Comware software image to the current storage medium
as the backup image (the file attribute is set to B).
If a backup system image already exists, the B file attribute of the
original image is removed.
<4> Modify Serial Interface Parameter
Change the baud rate of the console port.
The baud rate change is a one-time operation. The baud rate will
restore to the default (9600 bps) at reboot. To set up a console
session with the device after a reboot, you must change the baud rate
setting on the configuration terminal to 9600 bps.
<0> Exit To Main Menu
Return to the EXTEND-BOOTWARE menu.
NOTE:
To set the current storage medium, see "Managing storage media."
2. Enter 4 in the serial submenu to change the baud rate.
===============================<BAUDRATE SET>=============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------<Baudrate Available>---------------------------|
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200 |
|<0> Exit |
==========================================================================
Enter your choice(0-5):5
3. Enter an appropriate baud rate option. For example, enter 5 to select 115200 bps.
HP recommends that you change the default baud rate (9600 bps) to a higher baud rate for faster
file transfer before downloading a Comware software image with XMODEM through the console
port.
4. Enter 0 to return to the Serial submenu.
5. Choose an option from 1 and 2. For example, to upgrade the main Comware software image,
enter 2.
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash |
|<1> Download Image Program To SDRAM And Run |
|<2> Update Main Image File |
|<3> Update Backup Image File |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
=========================================================== =================
Enter your choice(0-4):
6. On the configuration terminal, configure the communication settings and transfer the upgrade file.
For more information, see "Using Xmodem to upgrade through the console port."