Release Notes - H3C S7500E-CMW520-R6616P05

H3C S7500E-CMW520-R6616P05 Release Notes
Hangzhou H3C Technologies Co., Ltd.
30
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2
slot 1!
# Reboot the switch to make the new boot files effective.
<Sysname> reboot
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
CAUTION:
 To prevent configuration loss, save the latest configuration changes before you reboot the switch.
 Boot files must be saved in the root directory of the storage medium. You can copy or move boot files
to the root directory. For more information about the boot-loader command, see Fundamentals in
the H3C S7500E Series Ethernet Switches Command Reference.
2. Install patches
# Download the patch files to the root directory of the storage medium of the active and standby main
boards, and then install the patch files with the patch install command.
<Sysname> system-view
[Sysname] patch install flash:
Patches will be installed. Continue? [Y/N]:y
Do you want to continue running patches after reboot? [Y/N]:y
Installing patches........
Installation completed, and patches will conti nue to run after reboot.
NOTE:
For more information about patch installation, see Fundamentals in the H3C S7500E Series Ethernet
Switches Configuration Guide.
Upgrade from the Boot Menu
You can upgrade the boot file for the main boards from the boot menu.
CAUTION:
You cannot simultaneously upgrade the active and standby main boards from the boot menu. To
ensure that the active and standby main boards use the same software version, upgrade them in turn.
Boot Menu
Upon power-on, the switch runs the Boot ROM program first and displays the following information:
Starting......
RAMLine.....OK
System is booting................
****************************************************************
* *
* BOOTROM, Version 3.01 *