3Com Switch 4200G Configuration Guide

RADIUS Configuration 183
When both the primary and secondary servers are in active or block state, the switch
sends packets only to the primary server.
Configuring the
Attributes for Data to
be Sent to RADIUS
Servers
CAUTION:
■ Generally, the access users are named in the userid@isp-name format. Where,
isp-name behind the @ character represents the ISP domain name, by which the
device determines which ISP domain it should ascribe the user to. However, some
old RADIUS servers cannot accept the user names that carry ISP domain names. In
this case, it is necessary to remove the domain names carried in the user names
before sending the user names to the RADIUS server. For this reason, the
user-name-format command is designed for you to specify whether or not ISP
domain names are carried in the user names sent to the RADIUS server.
Table 148 Set the status of RADIUS servers
Operation Command Description
Enter system view system-view —
Create a RADIUS
scheme and enter its
view
radius scheme radius-scheme-name Required
By default, a RADIUS
scheme named “system”
has already been created
in the system.
Set the status of the
primary RADIUS
authentication/authori
zation server
state primary authentication { block |
active }
Optional
By default, all the RADIUS
servers in a user-defined
RADIUS scheme are in the
active state; and the
RADIUS servers in the
default RADIUS scheme
“system” are in the block
state.
Set the status of the
primary RADIUS
accounting server
state primary accounting { block |
active }
Set the status of the
secondary RADIUS
authentication/authori
zation server
state secondary authentication { block |
active }
Set the status of the
secondary RADIUS
accounting server
state secondary accounting { block |
active }
Table 149 Configure the attributes for data to be sent to the RADIUS servers
Operation Command Description
Enter system view system-view —
Create a RADIUS
scheme and enter
its view
radius scheme radius-scheme-name Required
By default, a RADIUS scheme named
“system” has already been created
in the system.
Set the format of
the user names to
be sent to RADIUS
servers
user-name-format { with-domain |
without-domain }
Optional
By default, the user names sent from
the switch to RADIUS servers carry
ISP domain names.
Set the units of
measure for data
flows sent to
RADIUS servers
data-flow-format data { byte |
giga-byte | kilo-byte | mega-byte }
packet { giga-packet | kilo-packet |
mega- packet | one-packet }
Optional
By default, in a RADIIUS scheme, the
unit of measure for data is byte and
that for packets is one-packet.
Set the source IP
address used by
the switch to send
RADIUS packets
RADIUS scheme view
nas-ip ip-address
Optional
By default, no source IP address is
specified; and the IP address of the
outbound interface is used as the
source IP address.
System view
radius nas-ip ip-address