3Com Switch 4200G Configuration Guide

248 CHAPTER 28: CONFIGURATION FOR MIRRORING FEATURES
[4200G] interface gigabitethernet1/0/1
[4200G-GigabitEthernet1/0/1] port trunk permit vlan 10
[4200G-GigabitEthernet1/0/1] quit
[4200G] interface gigabitethernet1/0/2
[4200G-GigabitEthernet1/0/2] port trunk permit vlan 10
3 Configure Switch A.
<S4200G> system-view
[4200G] vlan 10
[4200G-vlan10] remote-probe vlan enable
[4200G-vlan10] quit
[4200G] interface gigabitethernet1/0/1
[4200G-GigabitEthernet1/0/1] port trunk permit vlan 10
[4200G-GigabitEthernet1/0/1] quit
[4200G] mirroring-group 1 remote-destination
[4200G] mirroring-group 1 monitor-port gigabitethernet1/0/2
[4200G] mirroring-group 1 remote-probe vlan 10
[4200G] display mirroring-group remote-destination
mirroring-group 1: type: remote-destination status: active
monitor port: GigabitEthernet1/0/2 remote-probe vlan: 10
Displaying and
Debugging Mirroring
After the above-mentioned configuration, you can use the display command in any
view to view the mirroring running information, so as to verify configuration result.
Table 218 Display and debug mirroring
Operation Command
Display parameter settings of a
mirroring group
display mirroring-group { group-id | all | local |
remote-destination | remote-source }
Display parameter settings of traffic
mirroring
display qos-interface { interface-type interface-num |
unit-id } mirrored-to