3Com Switch 4200G Configuration Guide

Configuring SNMP Basic Functions 279
Configuring SNMP
Basic Functions
The configuration of SNMP V3 configuration is different from that of SNMP V1 and
SNMP V2C, therefore SNMP basic function configurations for different versions are
introduced respectively. For specific configurations, refer to Table 249 and Table 250.
Private MIB DHCP MIB
DHCP MIB
QACL MIB
ADBM MIB
IGMP Snooping MIB
RSTP MIB
VLAN MIB
Device management
Interface management
—
QACL MIB —
ADBM MIB —
RSTP MIB —
VLAN MIB —
Device management —
Interface management —
Table 248 Common MIBs (Continued)
MIB attribute MIB content References
Table 249 Configure SNMP basic functions for SNMP V1 and SNMP V2C
Operation Command Description
Enter system view system-view —
Enable SNMP Agent snmp-agent Optional
By default, SNMP Agent is
disabled.
To enable SNMP Agent,
you can execute this
command or those
commands used to
configure SNMP Agent
features.
Set system information snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
Required
By default, the contact
information for system
maintenance is "R&D
Beijing, 3Com", the
system location is "Beijing
China", and the SNMP
version is SNMP V3.