3Com Switch 4200G Configuration Guide

18 CHAPTER 3: LOGGING IN THROUGH THE CONSOLE PORT
3 Specify not to authenticate users logging in through the Console port.
[4200G-ui-aux0] authentication-mode none
4 Specify commands of level 2 are available to users logging into the AUX user
interface.
[4200G-ui-aux0] user privilege level 2
5 Set the baud rate of the Console port to 19,200 bps.
[4200G-ui-aux0] speed 19200
6 Set the maximum number of lines the screen can contain to 30.
[4200G-ui-aux0] screen-length 30
7 Set the maximum number of commands the history command buffer can store to 20.
[4200G-ui-aux0] history-command max-size 20
8 Set the timeout time of the AUX user interface to 6 minutes.
[4200G-ui-aux0] idle-timeout 6
Console Port Login
Configuration with
Authentication Mode
Being Password
Configuration Procedure
Table 16 Console port login configuration with the authentication mode being password
Operation Command Description
Enter system view system-view —
Enter AUX user interface
view
user-interface aux 0 —
Configure to authenticate
users using the local
password
authentication-mode password Required
Set the local password set authentication password
{ cipher | simple } password
Required
Configure
the Console
port
Set the
baud rate
speed speed-value Optional
The default baud rate of an AUX
port (also the Console port) is
9,600 bps.
Set the
check mode
parity { even | mark | none |
odd | space }
Optional
By default, the check mode of a
Console port is set to none, that
is, no check bit.
Set the stop
bits
stopbits { 1 | 1.5 | 2 } Optional
The default stop bits of a Console
port is 1.
Set the data
bits
databits { 7 | 8} Optional
The default data bits of a Console
port is 8.
Configure the command
level available to users
logging into the user
interface
user privilege level level Optional
By default, commands of level 3
are available to users logging into
the AUX user interface.