3Com Switch 4200G Configuration Guide

346 CHAPTER 39: INFORMATION CENTER
Enabling Information
Output to a Log Host
Table 299 lists the related configurations on the switch.
To view the debug information of specific modules, you need to set the information
type as debug in the info-center source command, and enable the debugging
function on corresponding modules by using the debugging command.
Enabling Information
Output to the Console
Table 300 lists the related configurations on the switch.
To view debug/log/trap output information on the console, you should also enable
the corresponding debug/log/trap terminal display on the switch.
For example, to view log information of the switch on the console, you should not
only enable log information output to the console, but also enable logging terminal
display with the terminal logging command.
Enter the following commands in user view.
Table 299 Enable information output to a log host
Operation Command Description
Enter system view system-view —
Enable the information
center
info-center enable Optional
By default, the information center is
enabled.
Define an information
source
info-center source { modu-name
| default } channel
{ channel-number |
channel-name } [ { log | trap |
debug } * { level severity | state
state } *]
Required
Table 300 Enable information output to the console
Operation Command Description
Enter system view system-view —
Enable the information
center
info-center enable Optional
By default, the information center is
enabled.
Enable information
output to the console
info-center console channel
{ channel-number |
channel-name }
Required
By default, the switch does not
output information to the console.
Define an information
source
info-center source { modu-name
| default } channel
{ channel-number |
channel-name } [ { log | trap |
debug } * { level severity | state
state } *]
Required
Set the format of time
stamp
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Optional
Table 301 Enable debug/log/trap terminal display
Operation Command Description
Enable the
debug/log/trap
terminal display
function
terminal monitor Optional
By default, this function is enabled
for console user.