3Com Switch 4200G Configuration Guide

368 CHAPTER 41: Basic System Configuration and Debugging
The relation between the two switches is as follows:
Figure 119 Debugging information output
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Displaying Debugging
Status
Table 317 Enable debugging and terminal display
Operation Command Description
Enable system
debugging
debugging module-name [
debugging-option ]
By default, all debugging is
disabled in the system.
Because the output of debugging
information will affect the
efficiency of the system, disable
your debugging after you finish it.
Enable terminal display
for debugging
terminal debugging By default, terminal display for
debugging is disabled.
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal dis play switches
1
3
Debugging information
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal dis play switches
1
3
Debugging information
Table 318 Displaying debugging status
Operation Command Description
Display all enabled
debugging on the
specified device
display debugging { unit
unit-id } [ interface interface-type
interface-number | module-name ]
You can execute the display
command in any view.