3Com Switch 4200G Configuration Guide

Displaying and Maintaining GVRP 65
Network diagram
Figure 24 Network diagram for GVRP configuration
Configuration procedure
1 Configure switch A:
a Enable GVRP globally.
<S4200G> system-view
[4200G] gvrp
b Set the port GigabitEthernet1/0/1 to a trunk port, and allow all VLAN packets to
pass through the port.
[4200G] interface GigabitEthernet1/0/1
[4200G-GigabitEthernet1/0/1] port link-type trunk
[4200G-GigabitEthernet1/0/1] port trunk permit vlan all
c Enable GVRP on the trunk port.
[4200G-GigabitEthernet1/0/1] gvrp
2 Configure switch B:
a Enable GVRP globally.
<S4200G> system-view
[4200G] gvrp
b Set the port GigabitEthernet1/0/2 to a trunk port, and allow all VLAN packets to
pass through the port.
[4200G] interface GigabitEthernet1/0/2
[4200G-GigabitEthernet1/0/2] port link-type trunk
[4200G-GigabitEthernet1/0/2] port trunk permit vlan all
c Enable GVRP on the trunk port.
[4200G-GigabitEthernet1/0/2] gvrp
Displaying and
Maintaining GVRP
After the above configuration, you can use the display commands in any view to
display the configuration information and operating status of GVRP, and thus verify
your configuration. You can use the reset garp statistics command in user view to
clear GARP statistics.
Switch ASwitch BSwitch ASwitch B
E1/0/1
Switch ASwitch B
E1/0/2
Switch ASwitch B
Table 44 Display and maintain GVRP
Operation Command
Display GARP statistics display garp statistics [ interface interface-list ]
Display the settings of the GARP
timers
display garp timer [ interface interface-list ]
Display GVRP statistics display gvrp statistics [ interface interface-list ]
Display the global GVRP status display gvrp status
Clear GARP statistics reset garp statistics [ interface interface-list ]