3Com Switch 7750 Configuration Guide Guide

130 CHAPTER 16: IPX CONFIGURATION
directly connected to them. However, you cannot use such information directly.
Instead, the information is collected by the SAP agents of the switches on the
networks and saved in their server information tables.
IPX Configuration
Configuring IPX
Basic IPX Configuration
n
■ After the undo ipx enable command is executed, the IPX configurations are
cannot be recovered with the ipx enable command.
■ After IPX is enabled, you must assign a network number to a VLAN interface to
enable IPX on this VLAN interface. One network number can be assigned to
only one VLAN interface.
■ If the IPX network number of a VLAN interface is deleted, the IPX configuration
and static routing information of this VLAN interface will be deleted at the
same time.
Configuring IPX Routing Configuring IPX static routes
Tabl e 74 Configure IPX
Configuration task Description Detailed configuration
Basic IPX configuration Required “Basic IPX Configuration”
IPX routing configuration Required “Configuring IPX Routing”
IPX RIP configuration Required “Configuring IPX RIP”
IPX SAP configuration Required “Configuring IPX SAP”
IPX forwarding-related configuration Required “Configuring IPX forwarding”
Tabl e 75 Basic IPX configuration
Operation Command Description
Enter system view system-view -
Enable IPX ipx enable
Required
IPX is disabled by default
Enter VLAN interface view
interface Vlan-interface
vlan-id
-
Configure an IPX network
number for the VLAN
interface
ipx network network
Required
By default, the system does
not assign network numbers
to VLAN interface. That is, IPX
is disabled on all the VLAN
interfaces
Tabl e 76 Configure IPX static routes
Operation Command Description
Enter system view system-view -
Enable IPX ipx enable
Required
IPX is disabled by default