3Com Switch 7750 Configuration Guide Guide

Root Bridge Configuration 239
Configuration procedure (in system view)
Configuration procedure (in Ethernet port view)
n
Among aggregated ports, you can only configure the links of master ports as
point-to-point links.
If an auto-negotiating port operates in full duplex mode after negotiation, you can
configure the link of the port as a point-to-point link.
Table 168 Specify whether or not the links connected to the specified ports are
point-to-point links (in system view)
Operation Command Description
Enter system view system-view -
Specify whether or not the
links connected to the
specified ports are
point-to-point links
stp interface interface-list
point-to-point { force-true |
force-false | auto }
Required
The auto keyword is adopted
by default.
The force-true keyword
specifies that the links
connected to the specified
ports are point-to-point links.
The force-false keyword
specifies that the links
connected to the specified
ports are not point-to-point
links.
The auto keyword specifies to
automatically determine
whether or not the links
connected to the specified
ports are point-to-point links.
Table 169 Specify whether or not the link connected to a specific port is a point-to-point
link (in Ethernet port view)
Operation Command Description
Enter system view system-view -
Enter Ethernet port view
interface interface-type
interface-number
-
Specify whether or not the
link connected to the port is a
point-to-point link
stp point-to-point {
force-true | force-false |
auto }
Required
The auto keyword is adopted
by default.
The force-true keyword
specifies that the link
connected to the port is a
point-to-point link.
The force-false keyword
specifies that the link
connected to the port is not a
point-to-point link.
The auto keyword specifies to
automatically determine
whether or not the link
connected to the port is a
point-to-point link.