3Com Switch 7750 Configuration Guide Guide

254 CHAPTER 29: MSTP CONFIGURATION
Figure 59 Network diagram for rapid transition configuration
Configuration procedure
1 Configure the rapid transition feature in system view.
2 Configure in Ethernet port view.
n
■ The rapid transition feature can be enabled on root ports or alternate ports
only.
■ If you configure the rapid transition feature on the designated port, the feature
does not take effect on the port.
Port 1
Sw itch coming fr om ot her manufacturers
Port 2
Sw i t ch 7 7 5 0
Tabl e 187 Configure the rapid transition feature in system view
Operation Command Description
Enter system view system-view -
Enable the rapid transition
feature
stp interface interface-type
interface-number
no-agreement-check
Required
By default, the rapid transition
feature is disabled on a port.
Tabl e 188 Configure the rapid transition feature in Ethernet port view
Operation Command Description
Enter system view system-view -
Enter Ethernet port view
interface interface-type
interface-number
-
Enable the rapid transition
feature
stp no-agreement-check
Required
By default, the rapid transition
feature is disabled on a port.