3Com Switch 7750 Configuration Guide Guide

Static Route Configuration Example 269
Static Route
Configuration
Example
Network requirements
As shown in Figure 65, the masks of all the IP addresses in the figure are
255.255.255.0. It is required that all the hosts/Layer 3 switches in the figure can
interconnect with each other by configuring static routes.
Network diagram
Figure 65 Static route configuration
Table 193 Display the routing table
Operation Command Description
Display routing table summary display ip routing-table
You can execute the display
command in any view.
Display routing table details
display ip routing-table
verbose
Display the detailed
information of a specific route
display ip routing-table
ip-address [ mask ] [
longer-match ] [ verbose ]
Display the routes in a
specified address range
display ip routing-table
ip-address1 mask1
ip-address2 mask2 [ verbose
]
Display the routes discovered
by a specified protocol
display ip routing-table
protocol protocol [ inactive |
verbose ]
Display the tree-structured
routing table information
display ip routing-table
radix
Display the statistics of the
routing table
display ip routing-table
statistics
Clear the statistics about a
protocol in the routing table
reset ip routing-table
statistics protocol { all |
protocol }
Use the reset command in
user view.
Hos t A
1.1.5.2/24
1.1.5.1/24
1.1.2.2/24
1.1.2.1/24
1.1.1.1/24
1.1.1.2/24
1.1.4.2/24
1.1.3.1/24
1.1.3.2/24
1.1.4.1/24
Sw itc h A
Sw itc h B
Sw itc h C
Hos t C
Hos t B
Hos t A
1.1.5.2/24
1.1.5.1/24
1.1.2.2/24
1.1.2.1/24
1.1.1.1/24
1.1.1.2/24
1.1.4.2/24
1.1.3.1/24
1.1.3.2/24
1.1.4.1/24
Sw itc h A
Sw itc h B
Sw itc h C
Hos t CHos t C
Hos t BHos t B