3Com Switch 7750 Configuration Guide Guide

Basic RIP Configuration 277
Basic RIP
Configuration
Configuration
Prerequisites
Before configuring basic RIP functions, perform the following tasks:
■ Configuring the link layer protocol
■ Configuring the network layer addresses of interfaces so that adjacent nodes
are reachable to each other at the network layer
Configuring Basic RIP
Functions
Enabling RIP globally and on the interface of a specified network segment
Configuring RIP Route
Control
Setting the additional
routing metrics of an
interface
Optional
“Setting the
additional routing
metrics of an
interface”
Configuring RIP route
summary
Optional
“Configuring RIP
route summary”
Disabling the
receiving of host
routes
Optional
“Disabling the
receiving of host
routes”
Configuring RIP to
filter or advertise the
received routes
Optional
“Configuring RIP to
filter or advertise the
received routes”
Setting RIP preference Optional
“Setting RIP
preference”
Enabling RIP traffic
sharing across
interfaces
Optional
“Enabling RIP traffic
sharing across
interfaces”
Configuring RIP to
import routes from
another protocol
Optional
“Configuring RIP to
import routes from
another protocol”
RIP Network
Adjustment and
Optimization
Configuring RIP timers Optional
“Configuring RIP
timers”
Configuring split
horizon
Optional
“Configuring split
horizon”
Configuring RIP-1
packet zero field
check
Optional
“Configuring RIP-1
packet zero field
check”
Setting RIP-2 packet
authentication mode
Optional
“Setting RIP-2 packet
authentication mode”
Configuring a RIP
neighbor
Optional
“Configuring a RIP
neighbor”
Displaying and Maintaining RIP Configuration Optional
“Displaying and
Maintaining RIP
Configuration”
Table 195 RIP configuration tasks
Configuration Task Description Related section
Table 196 Enable RIP globally and on the interface of a specified network segment
Operation Command Description
Enter system view system-view -