3Com Switch 7750 Configuration Guide Guide

RIP Route Control 281
n
■ The filter-policy import command filters the RIP routes received from
neighbors, and the routes being filtered out will neither be added to the
routing table nor be advertised to any neighbors.
■ The filter-policy export command filters all the routes to be advertised,
including the routes imported by using the import-route command as well as
RIP routes learned from neighbors.
■ The filter-policy export command without the routing-protocol argument
filters all the routes to be advertised, including the routes imported by the
import-route command.
Setting RIP preference
Enabling RIP traffic sharing across interfaces
Configure RIP to filter
incoming routes
filter-policy { acl-number |
ip-prefix ip-prefix-name [
gateway ip-prefix-name ] |
gateway ip-prefix-name }
import [ interface
interface-type
interface-number ]
Required
By default, RIP does not filter
any incoming routes.
The gateway keyword is
used to filter the incoming
routes advertised from a
specified address.
filter-policy route-policy
route-policy-name import
Configure RIP to filter
outgoing routes
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ routing-protocol ]
Required
By default, RIP does not filter
any outgoing routes.
filter-policy route-policy
route-policy-name export
Table 202 Configure RIP to filter incoming/outgoing routes
Operation Command Description
Table 203 Set RIP preference
Operation Command Description
Enter system view system-view -
Enter RIP view rip -
Set the RIP preference preference value
Optional
The default RIP preference is
100.
Table 204 Enable RIP traffic sharing across interfaces
Operation Command Description
Enter system view system-view -
Enter RIP view rip -
Enable RIP traffic sharing
across interfaces
traffic-share-across-interface
Optional
By default, RIP traffic sharing
across interfaces is disabled.