3Com Switch 7750 Configuration Guide Guide

Console Port Login Configuration 37
Figure 4 Set port parameters
3 Turn on the switch. You will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as <SW7750>)
appears after you press the Enter key.
4 You can then configure the switch or check the information about the switch by
executing the corresponding commands. You can also acquire help by type the ?
character. The commands available on a switch are described in the related
module of the command manual.
Console Port Login
Configuration
Common Configuration Tab l e 12 lists the common configuration of Console port login.
Table 12 Common configuration of Console port login
Configuration Remarks
Console port
configuration
Baud rate
Optional
The default baud rate is 9,600 bps.
Check mode
Optional
By default, the check mode of the Console port
is set to "none", which means no check bit.
Stop bits
Optional
The default stop bits of a Console port is 1.
Data bits
Optional
The default data bits of a Console port is 8.