3Com Switch 7750 Configuration Guide Guide

42 CHAPTER 3: LOGGING IN THROUGH THE CONSOLE PORT
Network diagram
Figure 5 Network diagram for AUX user interface configuration (with the authentication
mode being none)
Configuration procedure
# Enter system view.
<SW7750> system-view
# Enter AUX user interface view.
[SW7750] user-interface aux 0
# Specify not to authenticate users logging in through the Console port.
[SW7750-ui-aux0] authentication-mode none
# Specify commands of level 2 are available to users logging into the AUX user
interface.
[SW7750-ui-aux0] user privilege level 2
# Set the baud rate of the Console port to 19,200 bps.
[SW7750-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[SW7750-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store
to 20.
[SW7750-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[SW7750-ui-aux0] idle-timeout 6
(1) RS-232 serial port (2) Console port (3) Configuration cable
(1)
(2)
(3)