3Com Switch 7750 Configuration Guide Guide

Console Port Login Configuration with Authentication Mode Being Scheme 47
Note that the command level available to users logging into a switch through the
scheme authentication mode depends on the authentication-mode scheme [
command-authentication ] command and the service-type terminal [ level
level ] command, as listed in
Table 19.
Configure the Console
port
Set the
baud
rate
speed
speed-value
Optional
The default baud rate of the AUX port
(also the Console port) is 9,600 bps.
Set the
check
mode
parity { even |
mark | none |
odd | space }
Optional
By default, the check mode of a Console
port is set to none, that is, no check bit.
Set the
flow
control
mode
flow-control {
hardware |
none | software
}
Optional
By default, a Console port does not
perform flow control.
Set the
stop
bits
stopbits { 1 | 1.5
| 2 }
Optional
The default stop bits of a Console port is
1.
Set the
data
bits
databits { 7 | 8 }
Optional
The default data bits of a Console port is
8.
Configure the command level
available to users logging into
the user interface
user privilege
level level
Optional
By default, commands of level 3 are
available to users logging into the AUX
user interface.
Make terminal services available
to the user interface
shell
Optional
By default, terminal services are available
in all user interfaces.
Set the maximum number of
lines the screen can contain
screen-length
screen-length
Optional
By default, the screen can contain up to
24 lines.
You can use the screen-length 0
command to disable the function to
display information in pages.
Set history command buffer size
history-comma
nd max-size
value
Optional
The default history command buffer size
is 10. That is, a history command buffer
can store up to 10 commands by default.
Set the timeout time for the
user interface
idle-timeout
minutes [
seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10 minutes,
the connection to a user interface is
terminated if no operation is performed
in the user interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Table 18 Console port login configuration with the authentication mode being scheme
Operation Command Description