3Com Switch 7750 Configuration Guide Guide

48 CHAPTER 3: LOGGING IN THROUGH THE CONSOLE PORT
Configuration Example Network requirements
Perform the following configuration for users logging in through the Console
port:
■ Configure the name of the local user to be "guest".
■ Set the authentication password of the local user to 1234567890 (in plain
text).
■ Set the service type of the local user to Terminal, the available command level
of the user to 2.
■ Configure to authenticate users logging in through the Console port in the
scheme mode.
■ The baud rate of the Console port is 19,200 bps.
■ The screen can contain up to 30 lines.
■ The history command buffer can store up to 20 commands.
■ The timeout time of the AUX user interface is 6 minutes.
Network diagram
Figure 7 Network diagram for AUX user interface configuration (with the authentication
mode being scheme)
Configuration procedure
# Enter system view.
<SW7750> system-view
# Create a local user named guest and enter local user view.
Tabl e 19 Determine the command level
Scenario
Command level
Authentication
mode
User type Command
authentication-
mode scheme [
command-auth
orization ]
Users logging
into the Console
port and pass
AAA&RADIUS or
local
authentication
The service-type
terminal [ level level ]
command is not
configured.
Level 0
The default command level
available for local users is level
0.
The service-type
terminal [ level level ]
command is
configured.
Determined by the level
argument
(1) RS-232 serial port (2) Console port (3) Configuration cable
(1)
(2)
(3)