3Com Switch 7750 Configuration Guide Guide

HABP Configuration Example 483
■ The two ports permit packets of all the VLANs.
Network diagram
Figure 123 Network diagram for HABP configuration
Configuration procedure
1 Configure Switch B.
# Enable HABP globally.
<SW7750>system-view
[SW7750]habp enable
# Configure the HABP server.
[SW7750]habp server vlan 2
# Enable the 802.1x globally.
[SW7750]dot1x
802.1x is enabled globally.
# Enable the 802.1x on GigabitEthernet1/0/2.
[SW7750]interface GigabitEthernet 1/0/2
[SW7750-GigabitEthernet1/0/2]dot1x
802.1x is enabled on port GigabitEthernet1/0/2.
2 Configure Switch A
# Enable HABP globally.
<SW7750>system-view
System View: return to User View with Ctrl+Z.
[SW7750]habp enable
Verify the configuration on the server.
[SW7750]display habp table
MAC Holdtime Receive Port
00e0-fc00-5004 41 GigabitEthernet1/0/2
00e0-fc00-5002 41 GigabitEthernet1/0/2
Switch A
Switch B
GigabitEthernet1/0/1
GigabitEthernet1/0/2
Switch A
Switch B
GigabitEthernet1/0/1
GigabitEthernet1/0/2
Switch A
Switch B
GigabitEthernet1/0/1
GigabitEthernet1/0/2
Switch A
Switch B
GigabitEthernet1/0/1
GigabitEthernet1/0/2