3Com Switch 7750 Configuration Guide Guide

RADIUS Configuration 505
c
CAUTION:
■ In an actual network environment, you can either specify two RADIUS servers
as the primary and secondary accounting servers respectively, or specify only
one server as both the primary and secondary accounting servers. In addition,
because RADIUS adopts different UDP ports to transceive
authentication/authorization packets and the accounting packets, you must set
a port number for accounting different from that set for
authentication/authorization.
■ Stop-accounting requests are critical to billing and will eventually affect the
charges of the users; they are important for both the users and the ISP.
Therefore, the switch should do its best to transmit them to the RADIUS
accounting server. If the RADIUS server does not respond to such a request, the
switch should first buffer the request on itself, and then retransmit the request
to the RADIUS accounting server until it gets a response, or the maximum
number of transmission attempts is reached (in this case, it discards the
request).
■ You can set the maximum number of real-time accounting request attempts in
the case that the accounting fails. If the switch makes all the allowed real-time
accounting request attempts but fails to perform accounting, it cuts down the
connection of the user.
■ The IP address and the port number of the default primary accounting server
"system" are 127.0.0.1 and 1646.
■ Currently, RADIUS does not support the accounting of FTP users.
Configuring Shared Keys
for RADIUS Packets
The RADIUS client and server adopt MD5 algorithm to encrypt the RADIUS packets
exchanged with each other. The two parties verify the validity of the exchanged
packets by using the shared keys that have been set on them, and can accept and
respond to the packets sent from each other only if both of them have the same
shared keys.
Set the maximum number of
real-time accounting request
attempts
retry realtime-accounting
retry-times
Optional
By default, the maximum
number of real-time
accounting request attempts
is 5. After that, the user
connection is cut down.
Table 384 Configure RADIUS accounting server
Operation Command Description
Table 385 Configure shared keys for RADIUS packets
Operation Command Description
Enter system view system-view -
Create a RADIUS scheme and
enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Set a shared key for the
RADIUS
authentication/authorization
packets
key authentication string
Required
By default, no shared key is
set.