3Com Switch 7750 Configuration Guide Guide

656 CHAPTER 59: MIRRORING CONFIGURATION
[SW7750-GigabitEthernet1/0/1] port link-type trunk
[SW7750-GigabitEthernet1/0/2] port trunk permit vlan 10
# Configure Switch C
<SW7750> system-view
[SW7750] acl number 2000
[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[SW7750-acl-basic-2000] quit
[SW7750] vlan 10
[SW7750-vlan10] remote-probe vlan enable
[SW7750-vlan10] quit
[SW7750] interface GigabitEthernet 1/0/1
[SW7750-GigabitEthernet1/0/1] port link-type trunk
[SW7750-GigabitEthernet1/0/1] port trunk permit vlan 10
[SW7750-GigabitEthernet1/0/1] quit
[SW7750] mirroring-group 1 remote-source
[SW7750] mirroring-group 1 reflector-port GigabitEthernet 1/0/3
[SW7750] mirroring-group 1 remote-probe vlan 10
[SW7750] interface GigabitEthernet 1/0/2
[SW7750-GigabitEthernet1/0/2] qos
[SW7750-qosb-GigabitEthernet1/0/2] mirrored-to inbound ip-group 2000
interface GigabitEthernet 1/0/3 reflector
[SW7750-GigabitEthernet1/0/2] display qos-interface GigabitEthernet
1/0/2 mirrored-to
GigabitEthernet1/0/2: mirrored-to
Inbound:
Matches: Acl 2000 rule 0 running
Mirrored to: mirroring-group 1
Configuring Mirroring to
Local I/O Module
Configuration prerequisites
■ The mirroring source port or the mirroring source I/O Module is specified, that
is, the direction of mirrored packets is specified.
■ The mirroring destination I/O Module is specified.
Configuration Procedure
Tabl e 519 Configure mirroring to a module
Operation Command Description
Enter system view system-view -
Create port mirroring groups
mirroring-group group-id
local
Required
Define the mirroring
destination I/O Module
mirroring-group group-id
monitor-slot slot-number
Required
The mirroring destination I/O
Module.