3Com Switch 7750 Configuration Guide Guide

Displaying SNMP 685
and "ifType" (interface type) to a trap packet. The two objects facilitate your
understanding and failure port location.
Displaying SNMP After the above configuration is completed, execute the display command in any
view to view the running status of SNMP, and to verify the configuration.
SNMP Configuration
Example
SNMP Configuration
Example
Network requirements
■ An NMS and Switch A are connected through the Ethernet. The IP address of
the NMS is 10.10.10.1 and that of the VLAN interface on Switch A is
10.10.10.2.
■ Perform the following configuration on Switch A: setting the community name
and access authority, administrator ID, contact and switch location, and
enabling the switch to sent trap packet.
Table 539 Display SNMP
Operation Command Description
Display system information of
the current SNMP device
display snmp-agent
sys-info [ contact | location |
version ]*
The display command can be
executed in any view
Display SNMP packet statistics
information
display snmp-agent
statistics
Display the switch fabric ID of
the current device
display snmp-agent {
local-switch fabricid |
remote-switch fabricid }
Display group information
about the device
display snmp-agent group [
group-name ]
Display SNMP user
information
display snmp-agent
usm-user [ switch fabricid
switch fabricid | username
user-name | group
group-name ]
Display the currently
configured community name
display snmp-agent
community [ read | write ]
Display the currently
configured MIB view
display snmp-agent
mib-view [ exclude | include
| viewname view-name ]