3Com Switch 7750 Configuration Guide Guide

Access Control Permission Configuration 701
in the NTP broadcast client mode will respond this packet and start the clock
synchronization procedure.
NTP multicast server mode
When the Switch 7750 operates in NTP multicast server mode, it multicasts a clock
synchronization packet periodically. The devices which are configured to be in the
NTP multicast client mode will respond this packet and start the clock
synchronization procedure. In this mode, the switch can accommodate up to
1,024 multicast clients.
n
■ The total number of the servers and peers configured for a switch can be up to
128.
■ After the configuration, the Switch 7750 does not establish connections with
the peer if it operates in NTP server mode. Whereas if it operates in any of the
other modes, it establishes connections with the peer.
■ If the Switch 7750 operates as a passive peer in peer mode, NTP broadcast
client mode, or NTP multicast client mode, the connections it establishes with
the peers are dynamic. If it operates in other modes, the connections it
establishes with the peers are static.
Access Control
Permission
Configuration
Access control permission to NTP server is a security measure that is of the
minimum extent. Authentication is more reliable comparing to it.
An access request made to an NTP server is matched from the highest permission
to the lowest, that is, in the order of peer, server, synchronization, and query.
NTP Authentication
Configuration
For the networks with higher security requirements, you can specify to perform
authentications when enabling NTP. With the authentications performed on both
the client side and the server side, the client is synchronized only to the server that
passes the authentication. This improves network security.
Prerequisites NTP authentication configuration involves:
■ Configuring NTP authentication on the client
■ Configuring NTP authentication on the server
Note the following when performing NTP authentication configuration:
■ If the NTP authentication is not enabled on a client, the client can be
synchronized to a server regardless of the NTP authentication configuration
Table 544 Configure the access control permission to the local NTP server
Operation Command Description
Enter system view system-view -
Configure the access control
permission to the local NTP
server
ntp-service access { peer |
server | synchronization |
query } acl-number
Optional
By default, the access control
permission to the local NTP
server is peer