3Com Switch 7750 Configuration Guide Guide

764 CHAPTER 71: INFORMATION CENTER
n
■ When there are multiple Telnet users or dumb terminal users, some
configuration parameters (including module filter, language and severity level
threshold settings) are shared between them. In this case, change to any such
parameter made by one user will also be reflected on all other user terminals.
■ To view debugging information of specific modules, you need to set the
information type as debug when defining the information source, and enable
debugging for corresponding modules through the debugging command as
well.
To view the debugging/log/trap output information on the monitor terminal, you
should enable the corresponding debugging/log/trap display function on the
switch.
For example, to view log information of the switch on a monitor terminal, you
need to not only enable log information output to the monitor terminal, but also
enable log information terminal display function with the terminal logging
command.
Perform the following configuration in user view.
Define an information source
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Required
Set the format of time stamp
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
This is to set the time stamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.
Table 591 Enable information output to a monitor terminal
Operation Command Description
Tabl e 592 Enable debugging/log/trap terminal display
Operation Command Description
Enable the
debugging/log/trap
information terminal display
function
terminal monitor
Optional
By default, this function is
enabled for console user.
Enable debugging
information terminal display
function
terminal debugging
Optional
By default, debugging
information terminal display is
disabled for terminal users.
Enable log information
terminal display function
terminal logging
Optional
By default, log information
terminal display is enabled for
console users.