3Com Switch 7750 Configuration Guide Guide

784 CHAPTER 73: BOOTROM AND HOST SOFTWARE LOADING

Figure 204 Sending file page

Step 9: After the download completes, the system displays the following

information:

Loading ...CCCCCCCCCC done!

Step 10: Reset HyperTerminal’s baud rate to 9600 bps (refer to Step 4 and 5).

Then, press any key as prompted. The system will display the following

information when it completes the loading.

Bootrom updating.....................................done!

■ If the HyperTerminal’s baud rate is not reset to 9600 bps, the system prompts

"Your baudrate should be set to 9600 bps again! Press enter key when ready".

■ You need not reset the HyperTerminal’s baud rate and can skip the last step if

you have chosen 9600 bps. In this case, the system upgrades BootROM

automatically and prompts "Bootrom updating

now.....................................done!".

Loading host software

Follow these steps to load the host software:

Step 1: Select <1> in Boot Menu and press <Enter>. The system displays the

following information:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):