3Com Switch 7750 Configuration Guide Guide

792 CHAPTER 73: BOOTROM AND HOST SOFTWARE LOADING
Figure 212 Upload file to the switch
Step 8: Configure 77503_02_00rc08.btm to be the BootROM at reboot, and then
restart the switch.
<SW7750> boot bootrom 77503_02_00rc08.btm slot 0
This will update BootRom file on board 0 . Continue? [Y/N] y
Board 0 upgrading BOOTROM, please wait...
Upgrade board 0 BOOTROM succeeded!
<SW7750> reboot
When rebooting the switch, use the file 77503_02_00rc08.btm as BootROM to
finish BootROM loading.
2 Loading host software
Loading the host software is the same as loading the BootROM program, except
for that the file to be downloaded is the host software file, and that you need to
use the boot boot-loader command to select the host software at reboot of the
switch.
n
■ The steps listed above are performed in the Windows operating system, if you
use other FTP client software, refer to the corresponding user’s guide before
operation.
■ Only the configurations steps concerning loading are illustrated here, for
detailed description on the corresponding configuration commands, refer to
the chapter "FTP and TFTP".
Remote Loading Using
TFTP
The remote loading using TFTP is similar to that using FTP. The only difference is
that TFTP is used instead off FTP to load software to the switch, and the switch can
only act as a TFTP client.