3Com Switch 7750 Configuration Guide Guide

798 CHAPTER 74: BASIC SYSTEM CONFIGURATION & DEBUGGING
Figure 213 Debugging information output
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Displaying Debugging
Status
Tabl e 610 Enable debugging and terminal display
Operation Command Description
Enable system debugging
debugging { all [ timeout
interval ] | module-name
debugging-option }
By default, all debugging is
disabled in the system.
Because the output of
debugging information will
affect the efficiency of the
system, disable your
debugging after you finish it.
Enable terminal display for
debugging
terminal debugging
By default, terminal display for
debugging is disabled.
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Term inal dis play switches
1
3
Debugging information
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Term inal dis play switches
1
3
Debugging information
Tabl e 611 Display the current debugging status in the system
Operation Command Description
Display all enabled debugging
on the specified device
display debugging [
interface interface-type
interface-number ] [
module-name ]
You can execute the display
command in any view.