3Com Switch 7750 Configuration Guide Guide

76
DEVICE MANAGEMENT
n
When Two 96Gbps Switch Fabrics (3C16886) are inserted into a Switch 7758
8-slot chassis the following functionality is available:
■ The first two SFP interfaces of the primary board and the first two SFP
interfaces of the secondary board work normally. Services will not be
interrupted during active-standby switchover.
■ The last two SFP interfaces on the primary board and the last two interfaces on
the secondary board do not work, and you can not see these four interfaces
through command line interface.
■ When the secondary board is inserted, configurations on the last two SFP
interfaces of the primary board will not be sent to the first two SFP interfaces of
the secondary board automatically, and you need to do this manually.
Introduction to Device
Management
The device management function of the Ethernet switch can report the current
status and event-debugging information of the boards to you. Through this
function, you can maintain and manage your physical device, and restart the
system when some functions of the system are abnormal.
Device Management
Configuration
Device Management
Configuration Tasks
Table 615 Device management configuration tasks
Operation Description Related section
Restart the Ethernet switch -
“Restarting the Ethernet
Switch”
Reboot a card of Ethernet
switch
Optional
“Rebooting a Card of
Ethernet Switch”
Schedule a reboot on the
switch
Optional
“Scheduling a Reboot on the
Switch”
Specify the ARP to be adopted
at reboot
Optional
“Specifying the APP to be
Adopted at Reboot”
Update the BootROM Optional “Updating the BootROM”
Upgrade BootROM along with
the upgrade of ARP
Optional
“Upgrading BootROM along
with the Upgrade of ARP”
Set card temperature
threshold
Optional
“Setting Card Temperature
Threshold”
Enable/disable RDRAM Optional “Enabling/Disabling RDRAM”