3Com Switch 7750 Configuration Guide Guide

Remote Ping Configuration 815
Displaying Remote Ping
Configuration
After the above Remote Ping configurations, you can execute the display
command in any view to display the information of operation status through
which you can verify the configuration effect.
Configuration Example Network Requirement
Perform an Remote Ping ICMP test between two switches. Like a ping test, this
test uses ICMP to test the RTTs of data packets between the source and the
destination.
Configuration procedure
# Enable Remote Ping Client.
<SW7750> system-view
System View: return to User View with Ctrl+Z.
[SW7750] remote ping-agent enable
# Create an Remote Ping test group administrator icmp.
Configure the test
parameters
Configure the
destination IP address
of the test
destination-ip
ip-address
Required
By default, no
destination IP address
is configured.
Configure the type of
the test.
test-type type
Optional
By default, the test
type is ICMP.
Configure the packet
sending times in each
test.
count times
Optional
By default, the packet
sending times in each
test is 1.
Configure the
automatic test
interval.
frequency interval
Optional
By default, the
automatic test interval
is zero, which
indicating the test will
be performed only
once.
Configure the timeout
time of the test.
timeout time
Optional
By default, the
timeout time is 3
seconds.
Execute the test test-enable Required
Table 629 Configure Remote Ping
Operation Command Description
Table 630 Display Remote Ping configuration
Operation Command Description
Display the information of
Remote Ping test history
display remote ping history
[ administrator-name
operation-tag ]
The display command can be
executed in any view.
Display the latest Remote Ping
test results
display remote ping results
[ administrator-name
operation-tag ]