3Com Switch 7750 Configuration Guide

138 CHAPTER 17: IPX CONFIGURATION
directly connected to them. However, you cannot use such information directly.
Instead, the information is collected by the SAP agents of the switches on the
networks and saved in their server information tables.
IPX Configuration
Configuring IPX
Basic IPX Configuration
n
■ After the undo ipx enable command is executed, the IPX configurations are
cannot be recovered with the ipx enable command.
■ After IPX is enabled, you must assign a network number to a VLAN interface to
enable IPX on this VLAN interface. One network number can be assigned to
only one VLAN interface.
■ If the IPX network number of a VLAN interface is deleted, the IPX configuration
and static routing information of this VLAN interface will be deleted at the
same time.
Configuring IPX Routing Configuring IPX static routes
Table 83 Configure IPX
Configuration task Description Detailed configuration
Basic IPX configuration Required “Basic IPX Configuration” on page
138
IPX routing configuration Required “Configuring IPX Routing” on page
138
IPX RIP configuration Required “Configuring IPX RIP” on page 139
IPX SAP configuration Required “Configuring IPX SAP” on page 141
IPX forwarding-related
configuration
Required “Configuring IPX forwarding” on page
144
Table 84 Basic IPX configuration
Operation Command Description
Enter system view system-view -
Enable IPX ipx enable Required
IPX is disabled by default
Enter VLAN interface view interface Vlan-interface vlan-id -
Configure an IPX network
number for the VLAN
interface
ipx network network Required
By default, the system does
not assign network numbers
to VLAN interface. That is, IPX
is disabled on all the VLAN
interfaces
Table 85 Configure IPX static routes
Operation Command Description
Enter system view system-view -