3Com Switch 7750 Configuration Guide

RIP Network Adjustment and Optimization 297
Configuration Tasks Configuring RIP timers
n
When configuring the values of RIP timers, you should take network performance
into consideration and perform consistent configuration on all routers running RIP
to avoid unnecessary network traffic and network route oscillation.
Configuring split horizon
n
Split horizon cannot be disabled on a point-to-point link.
Configuring RIP-1 packet zero field check
n
Some fields in a RIP-1 packet must be 0, and they are known as zero fields. For
RIP-1, zero field check is performed on incoming packets, those RIP-1 packets with
nonzero value in a zero filed will not be processed further. As a RIP-2 packet has
no zero fields, this configuration is invalid for RIP-2.
Setting RIP-2 packet authentication mode
RIP-2 supports two authentication modes, simple authentication and MD5
authentication.
Table 224 Configure RIP timers
Operation Command Description
Enter system view system-view -
Enter RIP view rip -
Set the values of RIP timers timers { update update-timer |
timeout timeout-timer } *
Optional
By default, Update timer
value is 30 seconds and
Timeout timer value is 180
seconds.
Table 225 Configure split horizon
Operation Command Description
Enter system view system-view -
Enter interface view interface interface-type
interface-number
-
Enable split horizon rip split-horizon Optional
By default, an interface uses
split horizon to send RIP
packets.
Table 226 Configure RIP-1 packet zero field check
Operation Command Description
Enter system view system-view -
Enter RIP view rip -
Enable zero field check of RIP-1
packets
checkzero Optional
By default, zero field check
is performed on RIP-1
packets.