3Com Switch 7750 Configuration Guide

320 CHAPTER 34: OSPF CONFIGURATION
Enabling OSPF Logging
Configuring OSPF
Network Management
System (NMS)
Displaying OSPF
Configuration
After the above configuration, you can use the display command in any view to
display and verify the OSPF configuration.
You can use the reset command in user view to reset the OSPF counter or
connection.
Table 248 Enable OSPF logging
Operation Command Description
Enter system view system-view -
Enter OSPF view ospf [ process-id [ router-id
router-id ]]
-
Enable the logging of
neighbor status changes
log-peer-change Optional
Log neighbor status changes.
Table 249 Configure OSPF MIB binding
Operation Command Description
Enter system view system-view -
Configure OSPF MIB binding ospf mib-binding process-id Optional
By default, MIB is bound to
the first enabled OSPF
process. When multiple OSPF
processes are enabled, you
can configure to which OSPF
process the MIB is bound.
Enable OSPF Trap snmp-agent trap enable
ospf [ process-id ] [ ifauthfail
| ifcfgerror | ifrxbadpkt |
ifstatechange |
iftxretransmit |
lsdbapproachoverflow |
lsdboverflow | maxagelsa |
nbrstatechange |
originatelsa | vifauthfail |
vifcfgerror | virifrxbadpkt |
virifstatechange |
viriftxretransmit |
virnbrstatechange ]*
Optional
You can configure OSPF to
send diversified SNMP TRAP
messages and specify a
certain OSPF process to send
SNMP TRAP messages by
process ID.