3Com Switch 7750 Configuration Guide

388 CHAPTER 38: ROUTE CAPACITY CONFIGURATION
n
The safety-value must be greater than the limit-value.
Enabling/Disabling
Automatic Protocol
Connection Recovery
c
CAUTION: If automatic protocol recovery is disabled, the broken OSPF or BGP
connection will not recover even when the free memory exceeds the safety value.
Therefore, do not disable this function if not necessary.
Displaying Route
Capacity
Configuration
After the above configuration, you can use the display command in any view to
display and verify the route capacity configuration.
Table 315 Set the lower limit and the safety value of switch memory
Operation Command Description
Enter system view system-view -
Set the lower limit and the
safety value of switch
memory
memory { safety safety-value |
limit limit-value }*
Optional
safety-value defaults to 40
and limit-value defaults to
30.
Table 316 Enable automatic protocol recovery
Operation Command Description
Enter system view system-view -
Enable automatic
protocol recovery
memory auto-establish
enable
Optional
By default, automatic protocol
connection recovery is enabled.
Disable automatic
protocol connection
recovery
memory auto-establish
disable
Optional
Perform this configuration with caution.
Table 317 Display route capacity configuration
Operation Command Description
Display memory occupancy of a
switch
display memory [ unit
unit-id ]
Optional
Display the route capacity
related memory setting and
state information
display memory limit Optional