3Com Switch 7750 Configuration Guide

AAA Configuration 519
Configuring the
Attributes of an ISP
Domain
c
CAUTION:
■ On a Switch 7750, each access user belongs to an ISP domain. You can
configure up to 16 ISP domains on the switch. When a user logs in, if no ISP
domain name is carried in the user name, the switch assumes that the user
belongs to the default ISP domain.
■ When charging a user, if the system does not find any available accounting
server or fails to communicate with any accounting server, it will not disconnect
the user as long as the accounting optional command has been executed.
■ The self-service server location function must cooperate with a
self-service-supported RADIUS server (such as CAMS). Through self-service,
users can manage and control their accounts or module numbers by
themselves. A server installed with the self-service software is called a
self-service server.
Table 400 Configure the attributes of an ISP domain
Operation Command Description
Enter system view system-view -
Create an ISP domain or enter
the view of an existing ISP
domain
domain isp-name Required
Activate/deactivate the ISP
domain
state { active | block } Optional
By default, once an ISP
domain is created, it is
in the active state and
all the users in this
domain are allowed to
access the network.
Set the maximum number of
access users that can be
contained in the ISP domain
access-limit { disable | enable
max-user-number }
Optional
After an ISP domain is
created, the number of
access users it can
contain is unlimited by
default.
Set the user idle-cut function idle-cut { disable | enable
minute flow }
Optional
By default, user
idle-cut function is
disabled.
Open/close the
accounting-optional switch
accounting optional Optional
By default, once an ISP
domain is created, the
accounting-optional
switch is closed.
Set the messenger function messenger time { enable limit
interval | disable }
Optional
By default, the
messenger function is
disabled.
Set the self-service server location
function
self-service-url { disable |
enable url-string }
Optional
By default, the
self-service server
location function is
disabled.