3Com Switch 7750 Configuration Guide

RADIUS Configuration 529
Configuring the
Attributes for Data to be
Sent to RADIUS Servers
c
CAUTION:
■ Generally, the access users are named in the userid@isp-name format. Where,
isp-name behind the @ character represents the ISP domain name, by which
the device determines which ISP domain it should ascribe the user to. However,
some old RADIUS servers cannot accept the user names that carry ISP domain
names. In this case, it is necessary to remove the domain names carried in the
user names before sending the user names to the RADIUS server. For this
Table 413 Set the status of RADIUS servers
Operation Command Description
Enter system view system-view -
Create a RADIUS
scheme and enter its
view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named “system” has already been
created in the system.
Set the status of the
primary RADIUS
authentication/authori
zation server
state primary
authentication { block |
active }
Optional
By default, all the RADIUS servers in
a customized RADIUS scheme are in
the block state.
Set the status of the
primary RADIUS
accounting server
state primary
accounting { block | active }
Set the status of the
secondary RADIUS
authentication/authori
zation server
state secondary
authentication { block |
active }
Set the status of the
secondary RADIUS
accounting server
state secondary
accounting { block | active }
Table 414 Configure the attributes for data to be sent to the RADIUS servers
Operation Command Description
Enter system view system-view -
Create a RADIUS
scheme and enter
its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named “system” has already been
created in the system.
Set the format of
the user names to
be sent to RADIUS
servers
user-name-format { with-domain
| without-domain }
Optional
By default, the user names sent
from the switch to RADIUS servers
carry ISP domain names.
Set the units of
measure for data
flows sent to
RADIUS servers
data-flow-format data { byte |
giga-byte | kilo-byte |
mega-byte } packet { giga-packet
| kilo-packet | mega- packet |
one-packet }
Optional
By default, in a RADIUS scheme,
the unit of measure for data is byte
and that for packets is one-packet.
Set the source IP
address used by
the switch to send
RADIUS packets
RADIUS scheme view
nas-ip ip-address
Optional
By default, no source IP address is
specified; and the IP address of the
outbound interface is used as the
source IP address.
System view
radius nas-ip ip-address