3Com Switch 7750 Configuration Guide

674 CHAPTER 61: QOS CONFIGURATION
n
■ Only non-type-A I/O Modules support the traffic redirect configuration.
■ The redirect configuration is effective only for the ACL rules whose actions are
permit.
■ Packets redirected to CPU will not be forwarded normally.
Configuration Example
■ Ethernet 2/0/1 of the switch is accessed into the 10.1.1.1/24 network segment.
■ Redirect all the traffic from the 10.1.1.1/24 network segment to Ethernet
2/0/7.
Configuration procedure:
<SW7750> system-view
[SW7750] acl number 2000
[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[SW7750-acl-basic-2000] quit
[SW7750] interface Ethernet 2/0/1
[SW7750-Ethernet2/0/1] qos
[SW7750-qosb-Ethernet2/0/1] traffic-redirect inbound ip-group 2000 i
nterface Ethernet 2/0/7
Configuring
Queue-scheduling
Refer to “Queue Scheduling” on page 663 for the introduction to queue
scheduling.
Configuration
Prerequisites
■ The queue-scheduling algorithm is specified.
■ The ports that need this configuration are specified.
Configuration Procedure
Table 545 Configure queue scheduling
Operation Command Description
Enter system view system-view -
Enter Ethernet port view interface interface-type
interface-number
-
Enter QoS view qos -
Configure the queue
scheduling mode
queue-scheduler { rr |
strict-priority | wrr
queue1-weight
queue2-weight
queue3-weight
queue4-weight
queue5-weight
queue6-weight
queue7-weight
queue8-weight }
Required
By default, the SP queue
scheduling algorithm is
adopted.
Display the parameters for
traffic redirect
display qos-interface
[ interface-type
interface-number ]
queue-scheduler
Optional
You can execute the display
command in any view.
Display all the QoS settings on
the port
display qos-interface
[ interface-type
interface-number ] all