3Com Switch 7750 Configuration Guide

708 CHAPTER 63: CLUSTER
■ A member device becomes a candidate device after being removed from the
cluster.
Management Device
Configuration
Management Device
Configuration Tasks
Enabling NDP Globally
and for Specific Ports
Configuring NDP-related
Parameters
Table 564 Management device configuration tasks
Operation Description Related section
Enable NDP globally and for
specific ports
Required “Enabling NDP Globally and for
Specific Ports” on page 708
Configure NDP-related
parameters
Optional “Configuring NDP-related
Parameters” on page 708
Enable NTDP globally and for
specific ports
Required “Enabling NTDP Globally and for
Specific Ports” on page 709
Configure NTDP-related
parameters
Optional “Configuring NTDP-related
Parameters” on page 709
Enable the cluster function Required “Enabling the Cluster Function”
on page 709
Configure cluster parameters Required “Configuring Cluster Parameters”
on page 709
Configure interaction for the
cluster
Required “Configuring Interaction for the
Cluster” on page 711
Table 565 Enable NDP globally and for a specific port
Operation Command Description
Enter system view system-view -
Enable NDP globally ndp enable Required
By default, NDP is
enabled globally
Enable NDP
for the
specified
Ethernet
ports
In system view ndp enable interface port-list You must choose
one of them
By default, NDP is
enabled on the
port
In
Ethernet
port view
Enter
Ethernet
port view
interface interface-type
interface-number
Enable NDP
on the port
ndp enable
Table 566 Configure NDP-related parameters
Operation Command Description
Enter system view system-view -
Configure the
holdtime of NDP
information
ndp timer aging
aging-in-seconds
Optional
By default, the aging time of NDP
packets is 180 seconds
Configure the interval
to send NDP packets
ndp timer hello seconds Optional
By default, the interval of sending NDP
packets is 60 seconds