3Com Switch 7750 Configuration Guide

Member Device Configuration 711
Building a cluster automatically
Configuring Interaction
for the Cluster
c
CAUTION: For Switch 7750 Ethernet switches, the IP address of the cluster public
FTP/TFTP server must be in the same network segment as that of the Layer-3
interface of management VLAN (VLAN1). Otherwise, member devices cannot
communicate with the cluster public FTP/TFTP server.
Member Device
Configuration
Member Device
Configuration Tasks
Table 571 Enable the cluster function automatically
Operation Command Description
Enter system view system-view -
Enter VLAN interface
view
interface Vlan-interface vlan-id Required
The Switch 7750 requires you to
configure the IP address of the
Layer 3 virtual interface of VLAN1
before you set up a cluster.
Otherwise, the cluster cannot be
set up.
Configure the IP
address of the VLAN
interface
ip address ip-address { mask |
mask-length }
Required
Enter cluster view cluster -
Configure the rang e
of the IP addresses of
the cluster
ip-pool
administrator-ip-address { ip-mas
k | ip-mask-length }
Required
Build a cluster
automatically
auto-build [ recover ] Optional
You can build clusters according
to corresponding prompts
Table 572 Configure interaction for the cluster
Operation Command Description
Enter system view system-view -
Enter cluster view cluster Required
Configure the public FTP server for the
cluster
ftp-server ip-address Optional
Configure the TFTP server for the cluster tftp-server ip-address Optional
Configure the logging host for the
cluster
logging-host ip-address Optional
Configure the SNMP host for the cluster snmp-host ip-address Optional
Table 573 Member device configuration tasks
Operation Description Related section
Enable NDP globally and for
specific ports
Required “Enabling NDP Globally and for
Specific Ports” on page 712
Enable NTDP globally and for
specific ports
Required “Enabling NTDP Globally and for
Specific Ports” on page 712