3Com Switch 7750 Configuration Guide

Configuring SNMP Basic Functions 741
Configuring SNMP
Basic Functions
The configuration of SNMP V3 configuration is different from that of SNMP V1
and SNMP V2C, therefore SNMP basic function configurations for different
versions are introduced respectively. For specific configurations, refer to Table 595
and Table 596.
Private MIB DHCP MIB
DHCP MIB
QACL MIB
ADBM MIB
IGMP Snooping MIB
RSTP MIB
VLAN MIB
Device management
Interface management
-
QACL MIB -
ADBM MIB -
RSTP MIB -
VLAN MIB -
Device management -
Interface management -
Table 594 Common MIBs
MIB attribute MIB content References
Table 595 Configure SNMP basic functions for SNMP V1 and SNMP V2C
Operation Command Description
Enter system view system-view -
Enable SNMP Agent snmp-agent Optional
By default, SNMP Agent is
disabled
To enable SNMP Agent,
you can execute this
command or those
commands used to
configure SNMP Agent
features
Set system information snmp-agent
sys-info { contact
sys-contact | location
sys-location | version {{v1 |
v2c | v3 }* | all }}
Required
By default, the contact
information for system
maintenance is “3Com
Corporation”, the system
location is “Marlborough,
MA”, and the SNMP
version is SNMP V3