3Com Switch 7750 Configuration Guide

Displaying the System Status 855
Returning from Current
View to Lower Level
View
Returning from Current
View to User View
Displaying the System
Status
You can use the following display commands to check the status and
configuration information about the system. For information about protocols and
ports, and the associated display commands, refer to relevant sections.
System Debugging
Enabling/Disabling
System Debugging
The Ethernet switch provides a variety of debugging functions. Most of the
protocols and features supported by the Ethernet switch are provided with
corresponding debugging functions. These debugging functions are a great help
for you to diagnose and troubleshoot your switch system.
The output of debugging information is controlled by two kinds of switches:
■ Protocol debugging, which controls whether the debugging information of a
protocol is output.
■ Terminal display, which controls whether the debugging information is output
to a user screen.
The relation between the two switches is as follows:
Table 666 Return from current view to lower level view
Operation Command Description
Return from current
view to lower level view
quit This operation will result in exiting
the system if current view is user
view.
Table 667 Return from current view to user view
Operation Command Description
Return from current
view to user view
return The composite key <Ctrl+Z> has
the same effect with the return
command.
Table 668 System display commands
Operation Command Description
Display the current
date and time of the
system
display clock You can execute the
display command in any
view
Display the version of
the system
display version
Display the information
about user terminal
interfaces
display users [ all ]
Display the debugging
status
display debugging [ interface
interface-type interface-number ]
[ module-name ]