3Com Switch 7750 Configuration Guide

856 CHAPTER 78: BASIC SYSTEM CONFIGURATION & DEBUGGING
Figure 228 Debugging information output
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Displaying Debugging
Status
Table 669 Enable debugging and terminal display
Operation Command Description
Enable system
debugging
debugging { all [ timeout
interval ] | module-name
debugging-option }
By default, all debugging is
disabled in the system.
Because the output of debugging
information will affect the
efficiency of the system, disable
your debugging after you finish
it.
Enable terminal display
for debugging
terminal debugging By default, terminal display for
debugging is disabled.
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal dis play switches
1
3
Debugging information
1
2
3
Protocol debugging switches
ON ONOFF
ONOFF
1
3
1
3
Terminal dis play switches
1
3
Debugging information
Table 670 Display the current debugging status in the system
Operation Command Description
Display all enabled
debugging on the
specified device
display debugging [ interface
interface-type interface-number ]
[ module-name ]
You can execute the display
command in any view.