3Com Switch 7750 Configuration Guide

862 CHAPTER 80: DEVICE MANAGEMENT
Restarting the Ethernet
Switch
You can perform the following operation in user view when the switch is in
trouble or needs to be restarted.
n
When rebooting, the system checks whether there is any configuration change. If
there is, it prompts you to indicate whether or not to proceed. This prevents you
from losing your original configuration due to oblivion after system reboot.
Rebooting a Module of
Ethernet Switch
It would be necessary to reset a module of Ethernet switch when failure occurs.
The value of slot-number ranges with products:
■ Switch 7754: 0 to 3
■ Switch 7757: 0 to 6
■ Switch 7758: 0 to 7
The value 0 indicates to reset the Fabric, equivalent to resetting the switch system.
Scheduling a Reboot on
the Switch
After you schedule a reboot on the switch, the switch will reboot at the specified
time.
Update the BootROM Optional “Updating the BootROM” on
page 863
Upgrade BootROM along with
the upgrade of ARP
Optional “Upgrading BootROM along with
the Upgrade of ARP” on page 863
Set module temperature
threshold
Optional “Setting Module Temperature
Threshold” on page 864
Enable/disable RDRAM Optional “Enabling/Disabling RDRAM” on
page 864
Enable system load sharing Optional “Enabling System Load Sharing”
on page 864
Identifying and Diagnosing
Pluggable Transceivers
Optional “Identifying and Diagnosing
Pluggable Transceivers” on page
865
Table 674 Device management configuration tasks
Operation Description Related section
Table 675 Restart the Ethernet switch
Operation Command Description
Restart the Ethernet switch reboot -
Table 676 Reset a card
Operation Command Description
Reset a module of Ethernet
switch
reboot [ slot slot-number ] Optional
Table 677 Schedule a reboot on the switch
Operation Command Description
Schedule a reboot on the switch, and
set the reboot date and time
schedule reboot at hh:mm
[ yyyy/mm/dd ]
Optional