3Com Switch 7750 Configuration Guide

Remote-ping Configuration 877
Remote-ping server configuration tasks
Remote-ping server configuration
Table 693 describes the configuration on remote-ping server, which is the same for
remote-ping test types that need to configure remote-ping server.
n
■ The remote-ping server function is needed only for jitter, TCP, and UDP tests.
■ You can configure multiple TCP/UDP listening services on one remote-ping
server, with each listening service corresponding to a specific destination IP
address and port number.
Remote-ping Client
Configuration
Remote-ping client configuration
After remote-ping client is enabled, you can create multiple test groups for
different tests, without the need to enable remote-ping client repeatedly for each
test group.
Different types of remote-ping tests are somewhat different in parameters and
parameter ranges. The following text describes the configuration on remote-ping
client for different test types.
n
Among the test types supported by remote-ping, only the ICMP test can be
performed when IRF fabric is enabled; all other test types cannot be performed
when IRF fabric is enabled. With IRF fabric enabled, you are allowed to configure
remote-ping tests and use the display commands to check your configurations,
Table 692 Remote-ping server configuration tasks
Item Description Related section
Enable the remote-ping server
function
The remote-ping server
function is needed only for
jitter, TCP, and UDP tests.
“Remote-ping server
configuration”
Configure a listening service
on the remote-ping server
You can configure multiple
TCP/UDP listening services on
one remote-ping server, with
each listening service
corresponding to a specific
destination IP address and
port number.
“Remote-ping server
configuration”
Table 693 Remote-ping server configuration
Operation Command Description
Enter system view system-view -
Enable the remote-ping server
function
remote-ping-server enable Required
Disabled by default.
Configure a UDP listening
service
remote-ping-server
udpecho ip-address
port-num
Required for UDP and jitter
tests
By default, no UDP listening
service is configured.
Configure a TCP listening
service
remote-ping-server
tcpconnect ip-address
port-num
Required for TCP tests
By default, no TCP listening
service is configured.