3Com Switch 7750 Configuration Guide

Edge Node Configuration 913
Edge Node
Configuration Tasks
The following table describes the edge node configuration tasks.
To clear the RRPP statistics information, use the reset rrpp statistics domain
domain-id [ ring ring-id ] command.
c
CAUTION:
■ The control VLAN of an RRPP domain cannot be a static VLAN already created
on the switch. If you configure a dynamic VLAN as the control VLAN of an
RRPP domain, the VLAN becomes a static VLAN automatically.
■ You are not recommended to configure a VLAN as both an RRPP control VLAN
and a remote-probe VLAN. (Refer to “Mirroring Configuration” on page 685
for information about remote-probe VLAN.)
■ You are not recommended to configure a VLAN as both an RRPP control VLAN
and an isolate-user-VLAN/sub VLAN. (Refer to “Isolate-User-VLAN
Configuration” on page 113 and “Configuring a Sub VLAN” on page 122.)
Table 708 Configure an edge node
Operation Command Description
Enter system view system-view -
Create an RRPP domain,
and enter RRPP domain
view
rrpp domain domain-id Required.
The command prompt
of RRPP domain view
depends on the
domain-id you input.
Specify a control VLAN for
the RRPP domain
control-vlan vlan-id Required
Specify the current switch
as a transit node of the
primary ring, and specify
the primary port and the
secondary port
ring ring-id node-mode transit
[ primary-port pri-port ]
[ secondary-port sec-port ] level
level-value
Required.
Level 0 identifies the
primary ring and level 1
identifies a subring.
Specify the current switch
as an edge node of the
subring, and specify a
common port and an edge
port
ring ring-id node-mode edge
[ common-port comm-port ]
[ edge-port edge-port ]
Required
Enable the primary ring ring ring-id enable Required
Enable the subring ring ring-id enable Required
Return to system view quit -
Enable RRPP rrpp enable Required
Display the brief
information of all RRPP
domains configured on the
switch
display rrpp brief Optional.
You can execute the
display command in
any view
Display RRPP configuration
de
tails on the switch
display rrpp verbose domain
domain-id [ ring ring-id ]
Display the RRPP packet
statistics on the switch
display rrpp statistics domain
domain-id [ ring ring-id ]
Clear the RRPP statistics
information
reset rrpp statistics domain
domain-id [ ring ring-id ]
Optional
You can execute the
reset command in user
view.