3Com Switch 7750 Configuration Guide

Assistant Edge Node Configuration 915
To clear the RRPP statistics information, use the reset rrpp statistics domain
domain-id [ ring ring-id ] command.
c
CAUTION:
■ The control VLAN of an RRPP domain cannot be a static VLAN already created
on the switch. If you configure a dynamic VLAN as the control VLAN of an
RRPP domain, the VLAN becomes a static VLAN automatically.
■ You are not recommended to configure a VLAN as both an RRPP control VLAN
and a remote-probe VLAN. (Refer to “Mirroring Configuration” on page 685
for information about remote-probe VLAN.)
■ You are not recommended to configure a VLAN as both an RRPP control VLAN
and an isolate-user-VLAN/sub VLAN. (Refer to “Isolate-User-VLAN
Configuration” on page 113 and “Configuring a Sub VLAN” on page 122.)
Table 709 Configure an assistant edge node
Operation Command Description
Enter system view system-view -
Create an RRPP domain,
and enter RRPP domain
view
rrpp domain domain-id Required.
The command prompt
of RRPP domain view
depends on the
domain-id you input.
Specify a control VLAN
for the RRPP domain
control-vlan vlan-id Required
Specify the current
switch as a transit node
of the primary ring, and
specify the primary port
and the secondary port
ring ring-id node-mode transit
[ primary-port pri-port ]
[ secondary-port sec-port ] level
level-value
Required.
Level 0 identifies the
primary ring and level 1
identifies a subring.
Specify the current
switch as an assistant
edge node of the
subring, and specify a
common port and an
edge port
ring ring-id node-mode assistant-edge
[ common-port comm-port ]
[ edge-port edge-port ]
Required
Enable the primary ring ring ring-id enable Required
Enable the subring ring ring-id enable Required
Return to system view quit -
Enable RRPP rrpp enable Required
Display the brief
information of all RRPP
domains configured on
the switch
display rrpp brief Optional.
You can execute the
display command in
any view
Display RRPP
c
onfiguration details on
the switch
display rrpp verbose domain
domain-id [ ring ring-id ]
Display the RRPP packet
statistics on the switch
display rrpp statistics domain
domain-id [ ring ring-id ]
Clear the RRPP statistics
information
reset rrpp statistics domain domain-id
[ ring ring-id ]
Optional
You can execute the
reset command in user
view.