3Com Switch 8800 Family Command Reference Guide

100 CHAPTER 7: IP ADDRESS CONFIGURATION COMMANDS
Parameter
interface-type interface-number: interface-type refers to the interface type, and
interface-number refers to the interface number. Refer to the interface command
in Port Command Manual for more information.
Description
Use the display ip interface command to display information about an interface.
Example
# Display the information about interface VLAN-interface 1.
<SW8800> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
DHCP packet deal mode: global
Tabl e 11 Description on the fields of the display ip interface command
Field Description
Vlan-interface1 current state Current state of the VLAN interface 1
Line protocol current state Current state of the Line protocol
Internet Address IP address
Broadcast address Broadcast address
The Maximum Transmit Unit Maximum transmission unit
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
The number of the input/output unicast
packets, bytes and broadcast packets are all 0
TTL invalid packet number The number of the received packets with
invalid TTLs