3Com Switch 8800 Family Command Reference Guide

134 CHAPTER 10: ETHERNET PORT CONFIGURATION COMMANDS
display jumboframe
configuration
Syntax
display jumboframe configuration
View
Any view
Parameter
None
Description
Use the display jumboframe configuration command to view the Jumbo frame
configuration on all cards. The supported Jumbo frame length ranges, as well as
the default values, may vary from card to card.
Example
# Display the current Jumboframe configuration in the system.
<SW8800>system-view
[SW8800] display jumboframe configuration
The jumboframe configuration at present:
Slot 2:
Allow jumbo frame to pass
The Maximum Frame Length is 1552
display port Syntax
display port { hybrid | trunk }
View
Any view
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input(normal): 0 packets, 0 bytes
- broadcasts, - multicasts
Input: 0 input errors, 0 runts, 0 giants, 0
throttles, 0 CRC
0 frame, 0 overruns, - aborts, 0 ignored, -
parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): 0 packets, 0 bytes
- broadcasts, - multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer
failures
0 aborts, 0 deferred, - collisions, 0 late
collisions
- lost carrier, - no carrier
The statistics information of input/output
packets and errors on this port. "-" indicates
that the item doesn’t supported by the switch.
Table 19 Description on the fields of the display interface command
Field Description