3Com Switch 8800 Family Command Reference Guide

11
ETHERNET LINK AGGREGATION
CONFIGURATION COMMANDS
Ethernet Link
Aggregation
Configuration
Commands
debugging lacp packet Syntax
debugging lacp packet [ interface interface-type interface-number [ to
interface-type interface-number ] ]
undo debugging lacp packet [ interface interface-type interface-number [ to
interface-type interface-number ] ]
View
System view
Parameter
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies a port or ports. The command without the parameter to specifies one
port, while the command with the parameter to specifies several contiguous
ports. interface-type indicates port type. interface-number indicates port number.
For more information, see the parameter description of the interface command.
Description
Use the debugging lacp packet command to enable LACP packet debugging for
the port. If you do not specify a port, the command enables packet debugging on
all LACP-enabled ports.
Use the undo debugging lacp packet command to disable LACP packet
debugging for the port.
Example
# Enable LACP packet debugging for Ethernet port Ethernet1/1/1.
<SW8800> debugging lacp packet interface ethernet1/1/1
debugging lacp state Syntax
debugging lacp state [ interface interface-type interface-number [ to
interface-type interface-number ] ] { { actor-churn | mux | partner-churn | ptx |
rx }* | all }